Dimensional Inspection, Test Blocks
The intent of this ILC/PT is to provide a means for the participant to determine the appropriateness and effectiveness of participant practices, training, and measurement uncertainty relating to measuring of fabricated parts.
This ILC/PT Kit involves the use of a CMM to complete multiple measurements. Six special features are measured resulting in 24 unique measurements, including angles. Measurements range from 0.0001 to 9.5 inches and approximately 20 degrees of angle. Expected resolution is 10 microns and 10 micro degrees of angle.
Participants are expected to be familiar with the operation and of their CMM in the inspection and measurement of fabricated parts against design tolerances, have all necessary equipment, and have measurement uncertainties appropriate for measurement of similar devices.
Dimensional Inspection, Test Blocks
The intent of this ILC/PT is to provide a means for the participant to determine the appropriateness and effectiveness of participant practices, training, and measurement uncertainty relating to measuring of fabricated parts.
This ILC/PT Kit involves the use of a CMM to complete multiple measurements. Four special features are measured resulting in 14 unique measurements, including angles. Measurements range from 1.0 to 11.0 inches and approximately 35 degrees of angle. Expected resolution is 10 microns and 10 micro degrees of angle.
Participants are expected to be familiar with the operation and of their CMM in the inspection and measurement of fabricated parts against design tolerances, have all necessary equipment, and have measurement uncertainties appropriate for measurement of similar devices.
Gage Block Set of 6
This six piece block set is intended for the participant to demonstrate technical competence in the calibration of longer gage blocks ranging from 3 in to 20 in. The associated reference uncertainties are in the order of 5 µin to 41 µin.
Steel Gage Blocks, Set of 10
The intent of this ILC/PT is to provide a means for the participant to determine the appropriateness and effectiveness of participant practices, training, and measurement uncertainty relating to calibration of steel gage blocks.
This ILC/PT Kit contains a set of 10 gage blocks, sizes: 0.1, 0.25, 0.75, 1, 3, 4 inches; and 5, 7, 20, 40 mm. Participants will use their own lab practices to perform 10 measurements of length.
Participants are expected to be familiar with, and have appropriate lab equipment and measurement uncertainties for calibration of similar devices.
Dimensional
GLASS SCALE-213
Vision Systems: Line Scales
The intent of this ILC/PT is to provide a means for the participant to determine the appropriateness and effectiveness of participant practices, training, and measurement uncertainty relating to calibration of linear Glass Line Scales.
This ILC/PT Kit contains a Glass Scale. Participants will use their lab practices to perform 18 inch and metric measurements in x and y axis including scales, circles, and squares from 0 to 6 inches, and 0 to 140 mm. Measurement values will be appropriate for calibration of similar devices.
Participants are expected to be familiar with, and have appropriate lab equipment and measurement uncertainties for calibration of similar devices.