Pressure
PRESSURE/VAC-111
Compound Gauge
The intent of this ILC/PT is to provide a means for the participant laboratory to determine the appropriateness and effectiveness of participant practices, training, and measurement uncertainty calculations relating to the measurement of Pressure and Vacuum.
This kit contains a compound Pressure/Vacuum Gauge. Participants will be asked to make 5 Pressure measurements between 5 and 30 psi, as well as 5 Vacuum measurements between 5 and 25 inHg on a digital gauge having 0.01 psi resolution.
Participants are expected to be familiar with, and have appropriate lab equipment and measurement uncertainties for calibration of similar devices.
1,000 psi Digital Test Gauge
The intent of this ILC/PT is to provide a means for participant laboratories to determine the appropriateness and effectiveness of participant practices, training and measurement uncertainty calculations relating to the calibration of a 1000 psi Digital Pressure Gauge.
Participants are asked to make a series of ten pneumatic pressure measurements between 100 and 1000 psi. The artifact resolution is 0.1 psi. The artifact accuracy specification is 0.1% FS from 20 to 100% of Full Scale, and 0.02% FS from 0 to 20% of Full Scale.
Participants are expected to be familiar with, and have appropriate lab equipment and measurement uncertainties for calibration of similar devices.
10K psi Transducer (Hydraulic)
This program is intended to provide a means for laboratories to validate their Hydraulic Pressure calibration practices over a range of 10 to 70 MPa (approximately 1459 to 10,153 psi).
This transducer provides the laboratory an opportunity to demonstrate calibration in the metric equivalent, Mpa. The manufacturer specification for the artifact within the test range is 0.004 to 0.009 MPa depending upon set point.
Participants are expected to be familiar with, and have appropriate lab equipment and measurement uncertainties for calibration of similar devices.
1,000 psi Digital Pressure Gauge
The intent of this ILC/PT is to provide a means for participants to evaluate the appropriateness and effectiveness of their practices, training, and measurement uncertainty calculations relating to the measurement of Pressure, 0 to 1000 psi.
Participants are asked to perform 11 measurements, on increasing and decreasing scale from 0 to 1000 psi. Resolution of the digital artifact is 0.01 psi. Pressure medium - use only clean, dry non-corrosive gases (pneumatic). Manufacturer specification for artifact accuracy is 0.01% FS (FS = 1000 psi).
Participants are expected to be familiar with, and have appropriate lab equipment and measurement uncertainties for calibration of similar devices.
0 to 15 inH20 Digital Pressure Gauge
The intent of this ILC/PT is to provide a means for participants to determine the appropriateness and effectiveness of their practices, training, and measurement uncertainty calculations relating to the measurement of Pressure in the range of 0 to 15 inH2O.
Artifact resolution is 0.0001 inH2O. Artifact specification is 0.010% Full Scale. Participants are asked to make 11 pressure measurements from 0.0 to 15.0 inH2O in ascending and descending set points. Measurement values will be appropriate for calibration of similar devices.
Participants are expected to be familiar with, and have appropriate lab equipment and measurement uncertainties for calibration of similar devices.
Artifact in Kit: Mensor, Model 2101 Digital Pressure Gauge
